REFUSOL REFUsol008K Instrucciones De Uso página 25

BA_REFUsol 008K-023K_V04.0_WW
2.2 Mounting the REFUsol
Mount the inverter by means of the self-centering wall-mounting plate which is included in the scope of
delivery.
CAUTION
When designing the attachment of the wall-mounting plate, take the weight of the inverter of 40 kg /
88.18492 lbs into account.

Mounting the wall bracket: Use the wall bracket to mark the positions of the holes to be
drilled. Attach the mounting plate to the wall with the outer holes.

Insert the upper edge of the cooler into the recess of the device holder. Push the inverter
upwards until it stops and place the lower edge of the cooler onto the wall holder. Ensure
that the rib profile is locked behind the nuts. Finally secure the inverter in these nuts using
the enclosed screws (M5x20). As an alternative, you can also use a padlock (shackle 4 mm
/ 0.15748 inches in diameter) as anti-theft protection. The design of the wall bracket
ensures that the inverter is automatically centered in this bracket.

To avoid adhesive residue on the inverter, we recommend to remove the display protector
of the inverter immediately after assembly from the display.
CAUTION
Copyright REFUsol GmbH
®
008K to 023K
Any failure to observe these requirements may result in a malfunction
of the device or may even cause severe personal injuries through
crushing, shearing, cutting, striking, or fire!
Avoid any load on the edge of the cover while mounting the device!
Do not use the cover to hold the device!
Only use the four holding grips to move the device!
25