Setting The Clock; Setting The Alarm - Lenco CR-740BK Manual De Usuario

Setting the Clock

1. With the unit OFF, press and hold the STOP/CLOCK button until the display flashes.
2. Press the <<I or I>>buttons to adjust the hours
3. Press the Stop/CLOCK button to set.
4. Press the <<I or I>>to adjust the minutes,
5. Press the Stop/CLOCK button to finish setting the time.

Setting the Alarm

1. With the unit OFF, press and hold the AL1 or AL 2 button until the display flashes.
Press the <<I or I>> buttons to select CD, buzzer (bb), or the FM radio.
Press the AL1 or AL2 button to set.
If using the FM radio, press the <<I or I>> buttons to adjust the radio frequency. Set the alarm hours
-
and minutes. After this alarm is set.
If using the CD player be sure a CD is loaded in the unit, press the <<I or I>>buttons to select the CD
-
track. Set the alarm hours and minutes. After this alarm is set.
If using the Clock "bb" sound. Set the alarm hours and minutes. After this alarm is set.
-
Once the configured alarm time has been reached, the alarm will sound. Press the SNOOZE button to
temporary stop the sound. After 9 minutes the sound will be active again. To stop the alarm sound or snooze
mode, press the AL1, AL2 or On/Off button.
2. If you are using CD mode as alarm sound, you can choose a music track between 1 and 30. If you select a
track beyond 30 then track 1 will be used
CD player
Note: this unit is not compatible with MP3 CDs.
Turn on the unit and press the SOURCE button to CD mode.
1. Open the CD door and insert the disc (label side up) and close the CD door.
Several seconds after closing the door, it will automatically play the first track; LED display shows the
number of tracks for a short time, then it will show the actual time again.
2. Use the volume dial to set the desired volume level.
3. Press the <<I or I>> buttons to play next track or previous track. And hold <<I or I>> buttons to fast
forward/backward the CD tracks.
4. Press the "Play/Pause" button to pause and playing the loaded CD.
5. During playback, press the "CD MODE/DISPLAY" button, it will repeat the current song, display REPEAT
LED will flash. Press the button a second time; It will repeat the whole disc, display REPEAT LED is on.
Press the button a third time; It will play the whole disc random, display RAND. LED is on. Press the button
next; It will cancel repeat/shuffle play.
Programming a CD
1. Press the CLOCK/STOP button to stop the CD, when it's playing.
2. Press the PROG button. "PO1" will show on the display.
3. Press the <<I or I>> buttons to select a track.
6