Hotpoint G187 Manual Del Propieratio página 12

Before you call for service...
PERFORMANCE (cont.] Possible Causes What To Do
Pilling Result of normal wear on , While this is not caused by the washer, you can slow the
poly-cotton blends and pilling process by washing garments inside out.
fuzzy fabrics
Snags, holes, tears, rips
or excessive wear
Pins, snaps, hooks, sharp , Fasten snaps, hooks,buttons and zippers.
buttons, belt buckles, , Remove loose items like pins, objects in pockets and
zippers and sharp objects sharp buttons.
left in pockets • Turn knits (which snag easily)inside out.
Undiluted chlorine bleach , Check bleach package instructions for proper amount.
, Never add undiluted bleach to wash or allow clothes to
come in contact with undiluted bleach.
Chemicals like hair bleach or , Rinseitems that may have chemicals on them before
dye, permanent wave solution washing.
Wrinkling Improper sorting , Avoid mixing heavy items (likework clothes)with light items
(like blouses).
, Try a fabric softener.
Overloading or incorrect • Load your washer so clothes have enough room to move
water level freely with water covering all of the clothes.
Incorrect wash and , Hatch Cycleselection to the type of fabric you are washing
dry cycles (especiallyfor easy care loads).
Repeated washing in , Wash in warm or cold water.
water that is too hot
SOUNDS Possible Causes Reason
"Metallic clicking" Shifter mechanism is , The drive system will engage at the start of agitate and
engaging or disengaging disengage when agitate is complete. This occurs multiple
times during the wash.
Back and forth "swoosh" Electric motor reversing , This machine has a drive system that doesn't use gears.
or light "clicking" sound direction This sound isthe motor rotating back and forth to clean
during agitate your laundry.
"Click" when water Relay switch , The relay makes a click sound when activated. The water
stops filling level activates the relay and stops filling.
"Clicking" behind Control Automatic Temperature , Two valves mix cold and hot water. The "clicking" iswhen either
Panel during fill Control Valve valve turns on or off to raise or lower the fill water temperature.
Water flaw changes Automatic Temperature , Two valvesmix coldand hotwater. Theflow changeswhen either
during fill Control Valve valve turns on or off to raise or lower the fill water temperature.
Motor "whining up" or Motor ramping up/down , The motor will speed up incrementally during the spin cycle.
"coasting down" in spin during spin cycle When spin is complete, it will coast until it stops.
"Humming" Water drain pump , The drain pump will make a humming sound when pumping
out water after agitation stops and continue until spin is
complete.
"Gurgling" Water drain pump , When the pump starts drawing in air, it starts to gurgle.
The washer should then begin spinning and the sound will
continue until it is done spinning.
Washer is noisy Washer is uneven , To level the front of the washer, adjust the front leveling legs
by rotating the individual leg in the proper direction for up
or down. To levelthe back of the washer, lift the back of the
machine 4" (11 cm) and set down.
12
Shipping rod is still assembled , To remove the shipping rod from the washer, pull the yellow
in the unit tag and remove the attached rod from the bottom right hand
side of the washer.