Sears Kenmore 758.154200 Manual Del Usuario página 9

Operating the Controls
The SET readout has a range of 25% to
65% and is adjusted in increments of 5%.
initially depressing the humidity button
will display the current humidity setting.
Each additional press of the button
increases the setting by 5%. A SET point
of 65% operates the humidifier
continuously regardless of the ROOM
reading. The humidistat that senses the
readings is located on the power cord.
Insure that this humidistat is free from
obstruction.
(continued)
Humidity Button,,
Using Your Humidifier
Refill Display and Auto Dry Out
Function
For maximum run time both bottles
should be filled. When both bottles are
empty the display alternates the room
humidity reading and "F" (FILL),
informing additional water is required.
Also at this time the unit will automatically
switch into AUTO DRY OUT MODE and
continue to run on the lowest speed until
the filter is dry.
__ QUlE_ COMFO_
Refill/Auto Dry Out
Mode Display
NOTE: During this time the room
humidity level will continue to be
monitored and the humidifier will cycle
the fan on and off until the filter is
completely dry. The fan will shut off
leaving you with a dry humidifier that is
less prone to mold and mildew growth.
if AUTO DRY OUT MODE is not desired,
refill the humidifier with water and the fan
will return to the set speed.
NOTE: Fan automatically switches to
lowest speed during AUTO DRY OUT
MODE.
Manual Dry Out
At the end of the humidification season or
if you do not plan to run the humidifier for
one week or more, a manual dry out
mechanism is provided to completely dry
out the humidifier cabinet.
To do this, simply slide the float retainer
located at the back of the humidifier
cabinet to the top position of the slot it is
located in. This will hold the float in an
upward position and the fan will run until
you turn the power off.
NOTE: Be sure to position float retainer
to the normal operating mode (lowest
position in slot) for normal humidifier
operation.
Below is a diagram of the slot the float
retainer is located in, at the back of the
cabinet.
Back of Cabinet
Top Position
is for Manual
Dryout
Bottom Position
J is for Normal
Operation Mode
Float
Retainer
Slot