REPLACING
THE WATER
FILTER
(_
eplace the water filter when the water
filter indicator turns red.
The water filter is located on the bottom
right side of the refrigerator.
To make changing the water filter easier, you may
want to shut off the water supply, and then drain
any water remaining in the water line by pressing
the Water button and then pressing a glass against
the water dispenser pad.
1. Turn the water filter 90 ° counter-clockwise.
2. Pull the water filter out of the filter housing.
3. Insert a new water filter into the filter housing.
4. Turn the new water filter 90 °clockwise.
Press and hold the Water button for 3 seconds
after changing the filter to reset the filter
indicator.
Confirm the indicator turns blue.
When you replace the water filter, some water
may leak from the water filter housing.
Make sure to wipe up any leakage that may
have occurred.
Removing residual matter from inside the
water supply line after installing a new
filter
ice
Water
1. Turn ON the main water supply.
2. Press the Water button on the control panel.
Place a cup or glass under the water outlet,
and then push the cup or glass against the
dispenser pad until you hear a "click".
3. Flush 3 gallons of water through the filter.
(Flush approximately 6 minutes.)
This will clean the water supply system and
remove air from the lines.
4. Additional flushing may be required in some
households.
5. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
%
A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser.
This is the result of air getting into the line.
It poses no problem to the operation of the
refrigerator.
Engl sh --27