Testing The Connection - Jandy AquaPure Ei Serie Manual De Instalación Y Operación

Page 16

3.6.3 Testing the Connection

Once the power pack has been wired to the AquaLink
connection:
1. Apply power to the power pack and the AquaLink RS Control System or PDA.
2. Wait about 20 seconds. If the connection was successful, a Ŧ symbol will appear in the top right corner of the
power pack display.
NOTE If the power pack does not connect to the controller, turn the power off to both devices and repeat steps 1
and 2. If the power pack still does not connect to the controller, re-check the wiring connections (see Section
3.6.2) and the controller setting on the power pack (see Section 3.6.1).
® RS Control System or PDA, follow these steps to test the