Installation Instructions - Evespring HSE03 Guia De Instalacion

HSE03 Voice Siren

Installation Instructions

General Introduction
The HSE03 Voice Siren is a two-way wireless alarm device which functions
not only as a siren, but also a strobe light with voice indicator functions. Its
great compatibility with our U-Net family security products makes it suitable for
smart home cloud based platforms such as Homesys.
HSE03 includes the following functions:
* Tamperproof protection
* Green and red flashing strobe light
* Visual and audible alarm indications
* 6 indicating beep sounds for identification
* EEPROM for non-volatile memory facility
* LED for identification, visual command confirmation and battery status
Product Layout
Figure 1 Front View
Figure 3 Back View
Figure 2 Under View
Figure 4 Inside View
Keys
A. Speaker
B. Voice Speaker
C. Backplate screws
D. Backplate
Functions
A. Siren Speaker Siren Warning 110 dB
B. Voice Speaker Voice Indicator 90 dB
E. Tamper Jumper Link A full alarm condition will be enabled when the device is
removed from the wall.
F. Learning Key Learn and clear ID codes.
G. Micro USB Update voice messages through the USB cable. (Factory
use only)
H. DC Jack Socket for connecting DC adapter
Binding with Homesys
1. Loosen and remove the locking screw from the bottom edge of the unit
counter clockwise.
2. Slide the backplate out of the unit.
3. Prepare four 1.5V alkaline batteries. Do not insert them into the unit yet.
4. Log into the Homesys account from a web browser.
1
E. Tamper Switch
F. Learning Key
G. Micro USB (Factory use only)
H. DC Jack