Safety Notices - Pfeiffer uBind 3.0 Manual De Instrucciones

EN
User Instructions uBind 3.0

Safety notices

This machine is intended for punching
holes in sheets of paper and plastic, and
for binding these materials with a plastic
binding comb. It may only be used for
these purposes whilst observing these
instructions for use.
Always punch a test hole in a scrap piece
of paper before punching a hole into the
original.
Empty the waste receptacle
Do not punch more than 12 sheets at a
time.
Description
Lever for punching and binding
1
Punching slot
2
Paper guide (right)
3 a
Paper guide (left)
3 b
Transport latch
4
Binding mechanism for opening and
5
closing the teeth of the binding comb
Waste receptacle
6
Punching slot for 4 holes (A4) or 3 holes
7
(LTR) for ring binding
Operation
1. Setting up the machine
Place the machine on a stable surface.
Move the machine close to you so you are
able to operate it well.
2. Hole punching
Punch a test hole in a scrap piece of paper
before punching holes in the original.
Align the stack of paper (max 12 sheets)
by hitting the edge on a level surface and
slide it all the way into the punching slot
The paper guide
paper guide
3 a
being used as possible.
Press the hole punch lever
and down to punch holes (see Fig. A).
6
uBind_3.0_Binding_machine_content_OS.indd 6
regularly.
6
2
is fixed. Adjust the
3 b
as close to the paper size
forward
1
3. Binding
Insert a plastic binding comb suitable for
the thickness of the items being bound
into the binding mechanism
side up.
Push the binding lever
so the teeth of the binding mechanism
reach into the binding comb.
Now push the binding lever
the teeth of the binding comb open far
enough to easily insert the paper (see
Fig. B).
Insert the punched stack of paper into
the open teeth of the binding comb.
Begin with the front cover sheet. To close
the binding comb, return the binding lever
to its original position (see Fig. C).
1
Remove the bound document.
4. 4 hole punch / 3 hole punch for ring
binding
Slide the sheets / film into the punching
slot and push the punch lever
7
ward and down to punch 4 holes (A4) or
3 holes (LTR).
5. Emptying the waste receptacle
Move the binding lever
position.
Pull out the waste receptacle
empty. Reinsert the receptacle and slide
it all the way back.
Note: The transport latch
6. Using the transport latch
Secure the lowered punch lever
transporting the machine by hooking the
transport latch
loop on the side of the handle.
.
open
5
slightly backward
1
back until
1
for-
1
to the original
1
and
6
must be open.
4
before
1
into the designated
4
20.04.16 13:02
5