Definitions: Safety Guidelines - DeWalt DWX725 Manual De Instrucciones

Definitions: Safety Guidelines

The definitions below describe the level of severity
for each signal word. Please read the manual and pay
attention to these symbols.
DANGER: Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
NOTICE: Indicates a practice not related to personal injury
which, if not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR
ANY D WALT TOOL, CALL US TOLL FREE AT: 1-800-4-D
E
(1-800-433-9258)
WARNING: For your own safety, read the work stand
instruction manual before using any accessory. Failure
to heed these warnings may result in personal injury and
serious damage to the work stand and the accessory. When
servicing this tool, use only identical replacement parts.
General Safety Instructions for Work
Stand
WARNING: To reduce the risk of personal injury:
• ALWAYS use eye protection. All users and bystanders must
wear eye protection that conforms to ANSI Z87.1.
• ALWAYS check the stability of the miter saw stand and the miter
saw attached to it before putting the stand or the saw into use
• DO NOT exceed the weight this stand can hold. The main
center beam of the work stand is designed to support 1000 lbs.
(453.6 kg.) safely in a work environment. It is unsafe to climb, sit
or stand on the stand.
• DO NOT modify or use stand for operations for which it is
unintended.
• DO NOT use the stand on uneven surfaces. The stand is
designed to be used on a flat, stable surface.
• DO NOT use on a slippery surface. The stand load capacity is
greatly reduced when used on slippery surfaces.
Components (Fig. 1)
WARNING: Never modify the stand or any part of it. Damage or
personal injury could result.
Refer to Figure 1 for Components List.
WALT FIG. 2
E
D
Preparation (Fig. 2)
1. Place the work stand on the ground with the folded legs facing
up.
1
C