Setting Up; Setting The Combination - Hartmann 10028372 Instrucciones De Uso

NOTE!
Risk of damage!
• When using the lock, make sure that it is not attached to hot
vehicle parts or in front of the exhaust opening.
• Protect vehicle parts and their sensitive surfaces, which may
come into contact with the lock, from scratches caused by friction
or vibration etc. You can do so, for example, using transparent,
self-adhesive protective film.
• Always keep the surfaces of the lock which face the bike clean.
Sand, dust and other soiling can damage surfaces (especially
paintwork) as they act like sandpaper.

5 | Setting up

3
4
1
Release button
2 Locking button

5.1 | Setting the combination

• Set the preset combination 0-0-0-0 so that the numbers align with the small bottom
setting point.
• Press the elongated locking button on the side of the lock. There is an audible click.
• Place a precision mechanics screwdriver on the reset button on the underside of the
lock housing. Press the screw in and turn it to the left at the same time.
• Set the desired combination so that it aligns with the bottom setting point.
• Turn the reset screw back again whilst still pressing it.
• Press the round release button. The locking mechanism pops out. The lock is now set
to your own combination.
1
2
Combination
3
Reset screw
4
13