Unpacking Instruction; Power Supply; General Description; Controls And Functions - Beamz DMX-024PRO Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the controller is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The controller must
also be directly connected to the mains and may be used. No dimmer or adjustable power supply.

GENERAL DESCRIPTION

This digital DMX 'scene setter ' light controller can control 24 light channels and gives total dimmer control over all 24 outputs. It
features 48 easily programmable memories with a storage capacity for 99 different light effect scenes per memory. It can be set
on automatic control or on music control via the built-in microphone or via an external audio signal. The speed and fade time for
the running light are also selectable. The digital DMX-512 control uses "addresses" for the individual control of the connected
light units. These outgoing addresses are pre-set to the numbers 1 to 24.

CONTROLS AND FUNCTIONS

1. PRESET A LED: Indicator LEDs for the setting of the slider controls from section A.
2. CHANNEL SLIDERS 1-12: these sliders will adjust the output of channel 1 to 12 from 0 to 100%
3. FLASH KEYS 1-12: Press to activate maximum channel output.
4. PRESET B LED: Indicator LEDs for the setting of the slider controls from section B.
5. SCENE LEDS: Indicator LEDs for the active scenes.
6. CHANNEL SLIDERS 13-24: these sliders will adjust the output of channel 13 to 24 from 0 to 100%
7. FLASH KEYS 13-24: Press to activate maximum channel output.
8