Care And Maintenance; Filter Change; Error Messages And Error Clearance - WellerFT LASERLINE 200V Manual De Uso

Care and maintenance

Filter change

Before doing any work on
the machine, pull the plug
out of the socket.
Use original replacement
parts only.
MIN 1x
year

Error messages and error clearance

Message/symptom
Extraction power missing
„
Loud extraction noises
„
Unit is not running
„
Filter display is not working
„
Sub-micron paricle becoming
„
dirty to quickly
Unable to detect USB medium
„
Reset unit
„
18
The degree of clogging of the filter is determined by differential pres-
sure measurement. The filter display indicates the current filter status
Red = filter full
Yellow = filter status > 80%
Green = filter status < 80%.%.
When the filter is used up, an audible signal sounds
once an hour
every half hour after 36 hours
every 10 min after 54 hours
continuously after 72 hours.
The suspended matter filter and the broadband gas filter are
complementary to one another and can be replaced together as a
compact filter. The compact filter must be changed once a year in
order to ensure it is fully functional. The fine dust filter (pocket filter)
is the preliminary stage of the compact filter and therefore must be
replaced more frequently. It is sufficient to replace the pocket filter if
the red LED does not come on after restarting the unit.
Possible cause
Pipe system leaking
„
Filter is dirty
„
Turbine speed too low
„
Air speed through extraction-
„
arm is too high speed
Thermally switched off
„
Minimum pressure hose was
„
not replaced after the filter
change
Pre-filter has not been used
„
USB medium inserted too long
„
Wrong USB medium > 100
„
mA
Remedial measures
Reseal the pipe system
„
change the filter
„
Increase the speed setting
„
Reduce the air speed (reduce
„
air quanitity)
Leave the unit to cool down.
„
Switch on again after approx.
3 hours.
Reconnect the hose to the
„
filter
Use prefilter
„
Do not leave USB medium
„
inserted for longer than 2
minutes. Remove USB
medium and switch unit off
and on again
Remove USB medium!
„