Operation - Craftsman 315.FS2000 Manual Del Operador

WARNING:
Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING:
Always remove battery pack from
the tool when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing
battery pack will prevent accidental starting that
could cause serious personal injury.
WARNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or acces-
sories not recommended by the manufacturer of
this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
ApplIcAtIoNS
You may use this tool for the purposes listed below:
 Finish and Trim (Interior and exterior)
 Door & Window Casing
 Door Jambs
 Baseboard
 Crown Molding
 Cabinetry
 Cap and Shoe Molding
 Molding
 Staircases
 Door and Window Trim
 Chair Rail
 Brickmold
 Hardwood Flooring
 Paneling
 Furniture
AttAcH BElt HooK
See Figure 1, page i.
The belt hook can be installed on the left or right side of
the nailer, depending on operator preference.
 Align belt hook and screw with right or left side screw
hole.
 Using a phillips head screwdriver (not included) tighten
securely.
INStAllING/REMovING BAttERY pAcK
See Figure 2, page i.
 to install, place the battery pack in the tool. Align the
raised rib inside the tool with the groove on the battery
pack.

opERAtIoN

 Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in tool
before beginning operation.
NotE: Squeeze LED light grip switch to activate nailer.
to remove battery pack:
 to remove, locate latches on battery pack and
depress to release battery pack from the tool.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
No-MAR pAD
See Figure 3, page i.
The no-mar pad attached to the nose of the tool helps
prevent marring and denting when working with softer
woods.
to remove or replace the pad:
 Remove the battery pack.
 Remove the pad by pulling it down and away from the
nose.
 To replace the pad, fit it into place over the nose and
push up to reseat.
On-board storage for the pad is located on the magazine
of the tool. An extra no-mar pad is provided in the on-
board storage area.
loADING tHE tool WItH BRAD NAIlS
See Figures 4 - 5, page i.
WARNING:
for use with this tool. The use of any other nails can
result in tool malfunction, leading to serious injuries.
WARNING:
self and others when loading nails. Failure to do so
could result in possible serious personal injury.
 Remove battery pack from the tool, if installed.
 With the nose of the tool pointed away from you,
squeeze magazine release button located at the rear of
the magazine and slide the magazine cover open.
 Place brad nails in the channel with nail tips pointing
down and resting on bottom of the channel.
 Push the magazine cover closed until it securely snaps
into place.
 Make sure that the magazine is securely locked in
place.
 Reinstall battery, and reactivate tool by pressing the
worklight grip switch.
9 – English
Use only the brad nails recommended
Keep the tool pointed away from your-