Philips SC1982 Manual Del Usuario página 25

Problem
I have pressed
the on/off/inten-
sity button, but
the appliance
does not switch
on.
The appliance
does not emit
a flash when I
press the flash
button.
I experience
unacceptable
skin discomfort
when I use the
appliance.
Possible Solution
cause
You have not Make sure that you insert the small plug into
plugged in the appliance socket properly. Check if you
the appliance have inserted the adapter into a live wall
properly. socket properly.
Your skin The READY/skin colour warning light blinks
colour is not rapidly. This indicates that the skin colour sen-
suitable for sor measured a skin colour that is too dark
treatment for safe treatment. You can try the appliance
with this on a different area where the skin is lighter.
appliance. If your dark skin colour is due to recent
sunbathing or tanning, wait for 2 weeks and
then try again. If the dark skin colour is your
natural colour, please check the table in chap-
ter 'Preparing for use', section 'Skin colour
and light intensity' to see if the appliance is
suitable for you at all.
The READY/ Make sure that the skin contact surface is
skin colour in full contact with the skin. When it is, the
warning light READY/skin colour warning light starts blink-
continues ing slowly and you can press the flash button
to light up to release a flash.
steadily.
The READY/ The appliance has a system error. Switch off
skin colour the appliance, unplug it and then try to switch
warning light it on again. If the problem persists, visit
and the in- www.philips.com/support or contact the
tensity lights Philips Consumer Care Centre.
are all on.
You did not Shave the treatment areas before you use
shave the the appliance. If shaving causes skin irritation,
treatment trim hairs as short as possible and use the
areas. appliance at a comfortable setting.
ENGLISH
25