GE Phantom Manual Del Usuario página 10

HANGING THE FAN
6.
Q
T
Carefully lift the fan assembly
up to the mounting bracket
(Q) and sit the hanger ball /
downrod assembly (T) in the
mounting bracket (Q) socket.
PREPARING THE ELECTRICAL CONNECTIONS
If you feel you do not have enough electrical wiring
knowledge or experience, have your fan installed by a
licensed electrician.
Follow the steps below to prepare the electrical connections.
After that, conform with the descriptions and diagrams on
next pages to connect the fan to your household wiring. Use
the wire nuts supplied with your fan. Secure the wire nuts
with electrical tape. Make sure there are no loose strands or
connections.
1.
Insert the receiver (M) into the mounting
bracket (Q) with the fl at side of the receiver
(M) facing the ceiling.
10
Fan installation
7.
Make sure the tab on the
mounting bracket socket is
properly seated in the groove
in the hanger ball / downrod
assembly (T). This will help to
balance the ceiling fan.
Q
M
T
WARNING: Failure to properly
seat the tab in the groove could
cause damage to wiring.
WARNING: To avoid possible
electric shock, be sure electricity
is turned off at the main fuse box
before wiring.