Install The Battery Pack; Remove The Battery Pack; Applications; Start The Machine - GreenWorks CUF301 Manual Del Operario

WARNING
The tines and the machine may damage even if you
move the machine with the motor switched off. To
prevent the tines from touching the ground while
moving please tilt the machine.

3.1.4 INSTALL THE BATTERY PACK

Figure 5
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.

3.1.5 REMOVE THE BATTERY PACK

Figure 5.
1. Open the battery door.
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
4

APPLICATIONS

• Breaking up garden soil to prepare seed bed for
planting.
• Shallow cultivating to remove weeds.
4.1

START THE MACHINE

Figure 4.
1. Press the safety lock button.
2. Pull the bail switch toward the handle while you hold
the safety lock button.
3. Release the safety lock button.
WARNING
Hold the machine with two hands during operation.
NOTE
Stand behind the machine with the tines on the ground
and the work area clean and free of obstructions.
English
4.2

STOP THE MACHINE

Figure 4.
1. Release the bail switch to stop the machine.
4.3

NARROW CULTIVATING WIDTH

The two outer tine blades can be removed from the unit
to allow a more narrow cultivating width.
1. Remove the ring pins from the holes on the ends of
the tine shaft.
2. Remove the outside tines and felts from the tine
shaft.
3. Place hitch pins in the holes.
4.4

OPERATION TIPS

The cultivator can be used to break up garden soil and
prepare a seedbed for planting. Plan ahead to leave
enough room between the seed rows to allow for
machine cultivating after the plants have grown.
1. Several passes over the same path may be required
to reach the desired depth. Do not try to dig too
deeply in the first pass.
2. If the machine jumps or bucks, allow the unit to
move forward at a slightly faster rate or install wheel
assembly.
3. If the cultivator stays and digs in at one spot, try
rocking it from side to side in order to start it moving
forward again.
4. If the soil is very hard, water a few days before
cultivating. Avoid working the soil when soggy or
wet. Wait a day or two after heavy rain for the
ground to dry.
5. Shallow cultivating less than 5cm. deep can be used
to disrupt weeds and aerate soil, without injuring
nearby plant roots. It should be done often so that
weeds do not grow large and cause tangling in the
tines of the unit.
5

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5
CAUTION
CAUTION
WARNING
EN