Unpack The Machine; Install The Handle; Install The Wheel; Install The Tines - GreenWorks 27072 Manual Del Operador

EN
Do not connect the machine to the power supply until you
assemble all the parts.
9.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
9.2

INSTALL THE HANDLE

3
1. Align the holes on the upper handle(1) with holes on the
lower handle(2).
2. Insert the bolts through the handles.
3. Use the wing nuts(3) to tighten them.
9.3

INSTALL THE WHEEL

\
WARNING
WARNING
WARNING
1
2
English
1. Insert the wheel assembly (6) into the support rod.
2. Align the wheel assembly hole to desired position.
3. Slide bolt through hole and attach the small hitch pin(13)
to bolt.
The wheel position of the machine is adjustable.You can
control the depth of operation through adjusting the wheel
position.
Wheels can be removed for greater tilling depth.
9.4

INSTALL THE TINES

12
The cultivator has four tines —two inner tines stamped B and
C and two outer tines stamped A and D. For correct operation
of the unit, the tines must be installed in the correct
orientation.
1. Put the machine on a flat and smooth surface.
2. Place tine C(10) on the tine shaft to the left of the gear
box. The stamped side of the tine should face away from
the gear box.
3. Place tine B(9) on the tine shaft to the right of the gear
box. The stamped side of the tine should face away from
the gear box.
4. Place a felt(12) washer on each side of the tine shaft, and
slide to rest against the inner tines.
5. Place the outer tine D(11) on the left side of the tine shaft.
The stamped side should face in toward tine C.
8
13
6
NOTE
NOTE
12