BOMANN MS 479 CB Instrucciones De Servicio página 33

• Fill your latte macchiato glass with the warm milk and milk
foam. Then add the espresso. We recommend a proportion
of 2/3 milk and 1/3 frothed milk and 1 cup of espresso.
Caffè Latte
• Use the stirrer to foam (8) the milk and prepare a small
quantity of hot milk as described in the Chapter "Instructions
for Operation".
• Cover a double espresso in a large cup of hot milk with a
little froth.
WARNING:
• Unplug the power plug before cleaning (6).
• Never immerse the motor/heating unit (4) into water. It could result
in an electric shock or fire.
CAUTION:
• Do not immerse the appliance in water: the electronic
components can be damaged.
• Do not use a wire brush or any abrasive items.
• Do not clean in the dishwasher.
Motor/heating unit (4)
• To clean the outside of the motor/heating unit (4), use only
a damp dishcloth with a little dishwasher detergent.
Stirrer (8 or 9) and foam tank (2)
• The stirrer (8 or 9) and the foam tank (2) can be cleaned
in soapy water.
• Let the components dry well before reassembly.
Troubleshooting
Problem Cause
The appliance Appliance without
does not turn power supply.
on or stops
operating.
The foam con-
tainer (2) was not
set properly on
the motor/heating
unit (4).
MS479CB_Instruction Manual_new
Cold drinks:
Cappuccino Freddo
• Use the stirrer to foam (8) the milk for a cappuccino freddo
and prepare cold frothed milk as described in "Instructions
for Operation".
• Fill your cappuccino cup first with espresso and then add
milk foam and cold milk. We recommend a proportion of
1/3 espresso, 1/3 milk froth and 1/3 milk.
Cleaning
Problem
The milk foams a
little or not at all.
Solution
- Check the out-
Milk escaping
let with another
from the lid.
appliance.
- Insert mains
The LEDs flash
plug (6).
when apparatus is
- Check the
switched on.
house fuse.
Set the foam tank
(2) correctly on
the motor/heating
unit (4) so that the
safety switch is
depressed.
Cause Solution
The device is too Allow the appli-
hot. Overheating ance to cool.
protection is
activated.
Appliance Contact our
defective. service center or
a specialist.
The milk is too Use milk at
hot. refrigerator
temperature.
The stirrer for Insert the stirrer
making foam (8) for creating foam
was not used. (8) and prepare
the milk again.
The load capacity Fill the tank up to
is exceeded. the MIN level.
The load capacity Reduce the load
is too large. capacity.
The device was Insert the foam
turned on without tank (2) on the
a properly insert- motor/heating unit
ed foam tank (2). (4) and turn on
the unit again.
01.07.16
33