Overview Of The Components; Before Use - HAEGER LUCCA PACK WO-PSC.003A Instrucciones De Uso

Overview of the components

1. Upper button
3. Led "In Operation"
5. Charging station

Before Use

1. Take the corkscrew, the charging station, the foil cutter and the power
adaptor out of the carton and remove all packaging material.
2. Place the foil cutter into the storage compartment under the charging
station.
3. Connect the power adaptor to the charging station by inserting the plug
into the socket on the rear of the charging station.
4. Place the charging station on a level, scratch-resistant and slip-free surface.
5. Insert the power adaptor into a mains power socket.
6. The corkscrew contains batteries that have to be recharged via the
charger. Therefore, the corkscrew itself requires no power cable. To charge
the corkscrew, place it in the charger.
7. Let the corkscrew stand for the 10 hours before using it, so that it becomes
fully charged. After this period, the corkscrew is ready for use.
NOTE:
When inserting the corkscrew into the charging station, it must:
– have its opening facing down,
– have the arrow on the corkscrew pointing to the marker line on the charging
station.
To operate your electric wine opener
The electric wine opener is operated by one single switch. The switch has two
functions:
– Press the lower part of the switch to remove a cork from a bottle.
– Press the upper part of the switch to release a cork from the mechanism
after you have removed from the bottle. (see Fig.1)
Before removing the cork you must remove any foil from the bottle using the foil
cutter provided. (see Fig.2)
1. Place the electric wine opener on top of the wine bottle making sure that it
remains as upright as possible at all times. If you hold the electric wine
opener at an angle to the bottle it will not remove the cork properly.(Fig. 3)
Instructions for use
2. Lower button
4. Foil cutter
6. Power AC/DC adaptor
English
3