Automatic Shut-Off - Profi Cook PC-DKI 1035 Instrucciones De Servicio

NOTE:
• The display shows the selected setting. The
relevant indicator light next to the display
will also light up.
• Please observe that the cooking behavior
in the pots differs. It depends on the nature
and the quality of the cooking vessels.
Enter Off Time
You can limit the cooking time with the
button.
1. Turn the appliance on and select any range or
temperature.
2. Press the TIMER button. The display shows
"0". The indicator light next to the display will
light up.
3. Set a turn-off time between 1 and 180 minutes
by using the or the
NOTE:
• Briefly press the
the time in increments of one minute. The
display will show the desired setting.
• Once you have set a time, the display will
remain for a few seconds. Then the func-
tion that you had selected previously will
be shown again.
• If you would like to verify the turn-off time,
press the TIMER one more time. The dis-
play will show the remaining running time
for a few seconds.
• You may change the previous turn-off time
at any time. The other settings (HEAT and
TEMP.) will remain.
• After the set time has elapsed, the cooking
time will automatically be turned off and a
beep will sound. The appliance is in stand-
by mode again.
• To cancel the turn-off time early, set the
TIMER to less than "1". The cooking plate
will turn off and will switch back to standby
mode. You may also turn the appliance off
directly with the
54
TIMER
button.
or the button to set
ON/STANDBY button.

Automatic shut-off

The hot plate turns off automatically after
120 minutes, if no input was given over the opera-
tor control panel during this time. This switching
serves as security for you.
Switching off
1. Press the ON/STANDBY button (5).
NOTE:
• The hot plate is reset from its operational
state to standby mode. The fan may con-
tinue to run for a period of time.
• The indicator lights next to the display will
go out.
• The display shows the message "H" for
"Hot" as long as the temperature of the
cooking surface is higher than 50°C.
• The display shows the message "L",
the temperature of the cooking
lower than 50°C.
2. Pull the plug.
3. Let the device cool down, before you put it
away.
Pan recognition
The device has a pot recognition function. It gives
several warnings to indicate that the cookware has
been removed. The message "– – –" appears on
the display. For safety reasons, the appliance will
switch to standby mode after about 15 seconds.
The fan may continue running.
In this context, please pay attention to the follow-
ing:
WARNING:
After use, the hot plate is to be switched off by
means of its regulation and control devices
[ ON/STANDBY button (5)] and not just by pan
recognition.
WARNING: Hazard of burns!
Because of the heat radiated during cooking,
dangerously high temperatures may occur at the
cooking zone after the cooking cycle.
when
surface is