Tabla de contenido
Publicidad
EX-PS
MA8
EX-PS
MA9
MA1
84
English
9. Maintenance (EX-PS only)
Make sure every cutter has the same length and edge
angles as illustrated. (MA8)
(4) Cutter length
(5) Filing angle
(6) Side plate angle
(7) Top plate cutting angle
■ GEAR CASE
The reduction gears are lubricated by multipurpose,
lithium-based grease in the gearcase.
Supply new grease every 25 hours of use or more
often depending on the job condition.
When adding lubricant, use a grease gun to insert
lubricant into the three grease nipples located on the
gear case. (MA9)
(1) Grease fitting
9. Maintenance (EX-HE only)
■ GEAR CASE
• The reduction gears are lubricated by multipurpose,
lithium-based grease in the gear case. At every 20
hours of use, supply the gear case with new grease.
• Remove the cutter holders before installing new
grease to arrange for old grease to exit.
NOTE
• When removing and installing the cutter holder(a),
use care not to allow any dirt and dust entering in to
the gear case.
Publicidad
Tabla de contenido
