Cleaning, Maintenance And Ordering Of Spare Parts; Replacing The Blade; Disposal And Recycling; Faults - Gardol GAF-E 20 Li OA Manual De Instrucciones

very sensitive surfaces, for example tiles.
Important! Only use brushes which are in
fl awless condition. Replace excessively worn
or damaged brushes immediately.
Always use both hands to operate the equipment.
Guide the equipment along the joints at a walking
pace. For uniform results carry out your work at
a constant speed. If necessary, guide the equip-
ment along the same joint several times.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Before putting away or cleaning the grass trim-
mer, switch off and remove the battery pack.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend that you clean the equipment
immediately after you use it.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the equipment.
Ensure that no water can get into the interior
of the equipment. The ingress of water into an
electric tool increases the risk of an electric
shock.
•
Use a brush to remove deposits from the
safety guard.

7.2 Replacing the blade

IMPORTANT! Be sure to remove the battery
pack before replacing!
•
To remove the blade, push the blade inwards
and remove it through the larger opening as
shown in Fig. 22.
•
To fit the new blade, proceed in reverse order.
Make sure the blade locks into place correctly
as shown in Fig. 7.
7.3 Maintenance
There are no other parts inside the equipment
which require maintenance.
Anl_GAF_E_20_Li_OA_SPK7.indb 19 Anl_GAF_E_20_Li_OA_SPK7.indb 19
GB
7.4 Ordering spare parts
Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Steel replacement brush:
Nylon replacement brush

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Defective components must be dispo-
sed of as special waste. Ask your dealer or your
local council.

9. Faults

The equipment does not work:
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to the customer service address
below.
- 19 -
Art. No.: 34.241.00
Art. No.: 34.241.10
03.08.2017 11:30:16 03.08.2017 11:30:16