1. Battery Compartment: Holds 2 X AAA batteries to power the unit.
2. Rain-proof and
wall-mounted
3. Outdoor Temperature range: -58°F ~ 158°F (-50 °C ~ 70 °C)
4. Humidity range: 10% ~ 99%
EN
Buttons
CHANNEL Selector (1,2,3): Slide to set Channel 1,2 or 3.
RESET: Press once to reset the remote sensor.
TX: Press to send temperature/humidity data to the receiver
manually.
Battery installation and setup
1. Open the battery compartment of the remote sensor as below
Figure;
2. Slide the channel selector switch inside the battery
compartment to your desired channel. For the first remote
you may select any channel, for additional remotes select
any unused channel;
3. Insert (2) AAA batteries according to the polarity markings.
Replace the battery compartment cover;
4. Open the battery compartment at the back of the base station
and insert (2) AAA batteries according to the polarity markings.
design
-6-
Replace the compartment door;
Note:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc), or rechargeable
(nickel cadmium) batteries.
For maximum performance in normal conditions we recommend
using good quality alkaline batteries.
If the battery power is low, there will be low battery icon showing
on the base station display.
Synchronize remote sensors with the base Station
Please note: each time the batteries (either base station or
remote sensor) are replaced or base station/remote sensor lost
connection, make sure to follow the below synchronization
process to pair and re-connect the base station and remote senor:
1. Position the remote sensor near the base station;
2. Once the batteries are installed in the base station, the RF
signal icon
(located on the upper left of the base station
display) will flash for 3 minutes, indicating that the base station
is in synchronization mode: it is waiting for remote sensors
to be registered.
3. If 3 minutes have passed after the batteries were installed in
the base station and the RF signal Icon
press and hold the CHANNEL/SYNC button of the base station
for 3-4 seconds until the RF signal icon is flashing again to
set it back in synchronization mode;
4. Install the batteries in the remote sensor and wait for a
moment or just press either the TX or RESET button inside
the remote sensor battery compartment, the remote sensor
temperature/humidity will show on the base station display
which indicates the synchronization is complete.
is no longer flashing,
-7-
EN