THERM PRO TP-65 Manual De Instrucciones página 5

5. If you have additional remote sensors, repeat the above
steps to register the remote sensors (up to 3 remote sensors
can be registered with one base station);
6. If you have registered more than one sensor, press the
EN
CHANNEL/SYNC button on the base station to select the
remote channel you want displayed permanently on the base
station. Press CHANNEL/SYNC button until you observe a
circular arrow on the base station LCD display under the
channel number. The unit will then auto-scroll, changing from
channel to channel every 5 seconds.
NOTE: If you have additional remote sensors, when you are
synchronizing remote sensors with the base station, the unit
will keep changing from channel to channel in the first three
minutes, after that you can select any channel you like or auto
-scroll mode.
Place the base station and remote sensor
1. The indoor base station (receiver) should always be placed
in a well ventilated indoor area and located away from vents,
heating or cooling elements, direct sunlight, windows, doors,
or any other openings.
2. The remote sensor (transmitter) can be placed on a flat
surface indoor or outdoor. Make sure the sensor is within
the transmission distance from the base station and with
minimal obstructions.
3. The base station and remote sensor can both be wall mounted.
NOTE: Although the remote sensor is designed to be rain-proof,
the remote sensor must be always placed upwards so that rain
won't get inside the sensor through the vent holes on the bottom
of the senor which functions to let the remote sensor detect the
environmental temperature and humidity more precisely and
quickly.
-8-
Maximum & minimum recorded temperature &
humidity
1. Press MAX/MIN/Clear button once to display the highest
indoor and outdoor temperatures/humidity recorded since
last reset. MAX is shown on the display.
2. Press MAX/MIN/Clear button again to display the lowest
indoor and outdoor temperatures/humidity recorded since
last reset. MIN is shown on the display.
3. To clear and reset the max/min records, when either the MAX
or MIN record is shown on the LCD display, press and hold
MAX/MIN/Clear for 3 seconds.
4. When either the MAX or MIN record is shown on the LCD
display, press ALL-TIME/24 button once to set the data record
time interval between ALL TIME or 24 hours. Note: Both ALL
TIME and 24 hours represent the time since you last time
manually cleared the history data or battery installation.
FCC statement of compliance
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
-9-
EN