Top door
Pull off the top cover and the corner cap.
1
To remove the covers, if necessary, use a
2
plastic card or spatula to remove the caps.
During unscrewing hold the refrigerator door
or it might be damaged. Remove the two
screws on the top hinge.
Pull out the door and place it on a soft and
3
clean surface.
Remove the two screws, the stop holder
4
and the stop.
Attach the supplied stop holder and the
5
stop and screw both to the left side of the
door.
Bottom door
Hold the freezer door and remove the two
1
screws on the middle hinge.
Pull the freezer door upwards and place it on
2
a soft and clean surface.
Remove the two screws, the stop holder
3
and the stop.
Screw the stop holder and the stop on the
4
left side of the door.
Remove the three blind caps from the
5
freezer compartment and insert them into
the open holes.
KFK45411-A2-NF_170728_V05_HR.indb 17
Refrigerator bottom
Caution
Pull out the mains plug!
Tilt the refrigerator so you can work at the
1
bottom or place the refrigerator fully on its
back. Make sure the back is placed on a soft
and clean surface.
Unscrew the feet on both sides. Loosen the
screws and remove both plates.
Remove the door hinge bolt and screw it
2
into the adjacent hole.
Replace both plates so that the right-hand
3
hinge plate is located on the left and screw
both plates to the bottom. Screw the feet
into the plates on both sides.
Place the refrigerator back on its feet and
adjust them if necessary.
English
17
28/7/17 4:33 pm