Dometic WAECO MagicComfort Serie Instrucciones De Montaje página 20

Safety and installation instructions
 Always follow the safety instructions of the vehicle manu-
facturer.
Some work (e.g. on retention systems such as the AIRBAG etc.)
may only be performed by qualified specialists.
NOTICE!
A
 To prevent damage when drilling, make sure there is sufficient
space on the other side for the drill head to come out.
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
NOTICE!
A
 When testing the voltage in electrical cables, only use a diode
test lamp or a voltmeter.
Test lamps with an illuminant take up voltages which are too
high and which can damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders
or insulating tape, for example to existing cables.
Observe the following instructions when using the seat heater:
 Do not place any sharp or heavy objects on the seat, as the seat heater
could otherwise be damaged.
 Persons with an impaired sensitivity to heat should only operate the seat
heater at level I.
 Do not place any heat insulating objects, such as blankets or coats, on the
seat when the seat heater is switched on.
 The seat heater can be damaged by fluids spilt on the seat.
 Never switch the seat heater on when it is wet.
20
MagicComfort MSH60, MSH601
EN