Dometic WAECO MagicComfort Serie Instrucciones De Montaje página 23

MagicComfort MSH60, MSH601
 Cable bushing sleeves (if necessary)
To fasten the cables you may require additional cable binders.
7.2 Installing the seat heater
The seat heater MagicComfort MSH60 includes heating elements for the
driver's and passenger seats; the seat heater MagicComfort MSH601 only
includes heating elements for the driver's or passenger seat.
Removing the seat
➤ Secure the vehicle against rolling away.
A
NOTICE!
For vehicles with side air bags in the seat backrest, observe the
manufacturer's instructions on removing the seats and the uphol-
stery.
➤ Check the suitability for installation using these installation instructions
and the manufacturer's information.
➤ Remove the fastening screws from the vehicle seat.
➤ Lift the seat out of the vehicle.
Preparing the seat
➤ Remove all plastic panelling from the seat to ensure the fastening of the
cover fabric can be reached.
➤ Separate the backrest from the seat (fig. 5, page 4 and fig. 6, page 4).
➤ Open the seat cover on the seat surface.
The cover fabric is usually tucked into a seam on the frame with a wide
cardboard strip or metal wire.
➤ Remove the fasteners using a screwdriver and pliers (fig. 7, page 4 and
fig. 8, page 5).
➤ Remove any upholstery staples or cross braces (fig. 9, page 5).
EN
Installing the seat heater
23