Ornytion 207P Manual De Usuario página 9

Description
The 207P is a wind direction electrical sensor. It is provided with a potentiometric transducer It
provides a voltage output that is a fraction of the power supply, proportional to wind direction.
The power supply can be applied only at the time of making the measure with minimal power
consumption. It is highly immune to electromagnetic interferences (industrial environment
degree).
Manufacturing
The body is made of anodized aluminium. The mobile parts are made of stainless steel and
anodized aluminium.
Assemblement
The 107A wind vane is issued with the back plate removed to reduce the packing volume. Before
installation it is necessary to mount the plate. The packaging includes the plate, two screws and a
1.5 mm Allen wrench.
Place the blade on the flat side of the rod as shown in the figure below, set screws and lightly
tighten
Installation
Fastening accessory
The packaging of the wind vane includes a fastening accessory that comes with a connector,
suitable for placing on support tubes with a 25mm (1'') diameter.
Before installing the wind vane you must wire the connector. We recommend the use of shielded
cable with three or more conductors with a section between 0.2 and 0.8 mm 2 (24 AWG to 18
AWG). The outer diameter of the cable should not exceed 8 mm.
9