Caution On Lithium-Ion Battery; Power Tool - HIKOKI CL 14DSL Instrucciones De Manejo

Cortadora de varilla con rosca a batteria
Ocultar thumbs Ver también para CL 14DSL:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62
16. Do not insert object into the air ventilation slots of the
charger.
Inserting metal objects or infl ammables into the charger
air ventilation slots will result in electrical shock hazard
or damaged charger.
17. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery life
becomes too short for practical use. Do not dispose of
the exhausted battery.
18. Using an exhausted battery will damage the charger.

CAUTION ON LITHIUM-ION BATTERY

To extend the lifetime, the lithium-ion battery equips with
the protection function to stop the output.
In the cases of 1 to 3 described below, when using this
product, even if you are pulling the switch, the motor may
stop. This is not the trouble but the result of protection
function.
1. When the battery power remaining runs out, the motor
stops.
In such case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In this
case, release the switch of tool and eliminate causes of
overloading. After that, you can use it again.
3. If the battery is overheated under overload work, the
battery power may stop.
In this case, stop using the battery and let the battery
cool. After that, you can use it again.
Furthermore, please heed the following warning and
caution.
WARNING
In order to prevent any battery leakage, heat generation,
smoke emission, explosion and ignition beforehand,
please be sure to heed the following precautions.
1. Make sure that swarf and dust do not collect on the
battery.
○ During work make sure that swarf and dust do not fall on
the battery.
○ Make sure that any swarf and dust falling on the power
tool during work do not collect on the battery.
○ Do not store an unused battery in a location exposed to
swarf and dust.
○ Before storing a battery, remove any swarf and dust that
may adhere to it and do not store it together with metal
parts (screws, nails, etc.).
2. Do not pierce battery with a sharp object such as a
nail, strike with a hammer, step on, throw or subject the
battery to severe physical shock.
3. Do not use an apparently damaged or deformed battery.
SPECIFICATIONS

POWER TOOL

Model
No-load stroke
Capacity: Soft steel studs
(Size of studs for cutting)
Rechargeable battery
Weight*
* Weight according to EPTA-Procedure 01/2014. Depending on attached battery. The heaviest weight is measured with
BSL1460 (CL14DSL) and BSL36B18 (CL18DSL).
4. Do not use the battery in reverse polarity.
5. Do not connect directly to an electrical outlets or car
6. Do not use the battery for a purpose other than those
7. If the battery charging fails to complete even when a
8. Do not put or subject the battery to high temperatures or
9. Keep away from fire immediately when leakage or foul
10. Do not use in a location where strong static electricity
11. If there is battery leakage, foul odor, heat generated,
12. Do not immerse the battery or allow any fl uids to fl ow
CAUTION
1. If liquid leaking from the battery gets into your eyes,
2. If liquid leaks onto your skin or clothes, wash well with
3. If you fi nd rust, foul odor, overheating, discolor,
WARNING
If an electrically conductive foreign object enters the
terminals of the lithium ion battery, a short-circuit may
occur resulting in the risk of fi re.
following matters when storing the battery.
○ Do not place electrically conductive cuttings,
○ Either install the battery in the power tool or store
CL14DSL
○ M10 × 1.5
○ M8 × 1.25
○ W3/8" × 1.5875
BSL1430:
BSL1440:
Li-ion 14.4 V
Li-ion 14.4 V
(3.0 Ah 8 cells)
(4.0 Ah 8 cells)
2.8 – 3.1 kg
cigarette lighter sockets.
specified.
specified recharging time has elapsed, immediately
stop further recharging.
high pressure such as into a microwave oven, dryer, or
high pressure container.
odor are detected.
generates.
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove
it from the equipment or battery charger, and stop use.
inside. Conductive liquid ingress, such as water, can
cause damage resulting in fi re or explosion. Store your
battery in a cool, dry place, away from combustible and
fl ammable items. Corrosive gas atmospheres must be
avoided.
do not rub your eyes and wash them well with fresh
clean water such as tap water and contact a doctor
immediately.
If left untreated, the liquid may cause eye-problems.
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
deformation, and/or other irregularities when using the
battery for the fi rst time, do not use and return it to your
supplier or vendor.
nails, steel wire, copper wire or other wire in the
storage case.
by securely pressing into the battery cover until
the ventilation holes are concealed to prevent
short-circuits (See Fig. 1).
30 min
-1
○ M6 × 1
BSL1450:
BSL1830:
Li-ion 14.4 V
Li-ion 18 V
(5.0 Ah 8 cells)
(3.0 Ah 10 cells)
English
Please observe the
CL18DSL
BSL1840:
BSL1850:
Li-ion 18 V
Li-ion 18 V
(4.0 Ah 10 cells)
(5.0 Ah 10 cells)
2.9 – 3.5 kg
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cl 18dsl

Tabla de contenido