Dremel 3D40 FLEX Instrucciones De Funcionamiento Y Seguridad página 27

DM 2610039151 10-18.qxp_3D40 10/8/18 10:34 AM Page 27
LEVELING BUILD PLATE
Dremel 3D40 operation or until it has
cooled down to 60°C (140°F). Contact with
the extruder tip during or after operation
before tip has cooled may result in personal
injury.
It is important you level the build plate every
time you replace the build tape or reinstall
the build plate to ensure that the build plate
is evenly spaced from the extruder head.
Make sure to remove any air bubbles from
between the build plate and the build tape.
Not leveling the build plate or eliminating air
bubbles may cause objects to not build
properly.
1. Make sure you have placed build tape on
build plate and no objects are present.
Applying build tape after leveling may
effect the consistency of your object.
2. Tap "Level" on 3D40's touch screen.
3. The extruder and build platform will move
into position to level the build plate. 3D40
will first check level at the back center of
the build plate. The two knobs under the
build platform are used to raise and lower
the build platform on the left and right. The
extruder contains a sensor that detects if
the bed is level, no additional tools are
necessary.
4. The touch screen will indicate if your build
plate is too high or too low. If the build
plate is too high, adjust the appropriate
knob by rotating right until you hear a
"beep" and the touch screen indicates that
it is ready to verify that the bed is level.
Getting Ready to Build
Do not touch the
extruder tip during
5. If the build plate is too low, adjust the knob
by rotating left until you hear a "beep" and
the touch screen indicates that it is ready
to verify that the bed is level.
6. Tap "Verify" to check the bed level. If
further adjustment is needed the touch
screen will indicate the direction, if the
level is correct, the extruder will move to
the next point and the level process can
be repeated.
7. Repeat steps 4-6 for the second position,
when bed is fully level the extruder will
automatically move to the calibration
position and complete the leveling
process.
27