Interconnect Cables - Arcam Muso Manual De Instrucciones

Interconnect cables

We recommend the use of high-quality audio interconnect cables to ensure the best
performance of your system. All cables should be kept as short as possible. It is good
practice to make sure that any mains power supply cabling is kept as far away as possible
from your audio cables, to eliminate unwanted noise in the audio signals.
Connecting to a sound source
Make sure that your amplifier/sound processor/receiver is switched off before connecting
the Muso speakers. Refer to your amplifier/receiver/sound processor handbook to identify
the speaker terminals and their polarity. For each speaker, connect the positive terminal of
the amplifier (normally coloured red or labelled with '+' to the red (positive) terminal on
the Muso. Similarly, connect the negative terminal of the amplifier (normally coloured black
or labelled with '-') to the black (negative) terminal on the Muso.
Turn the sound source amplifier volume down to minimum before switching on. Switch
the amplifier(s) on, select a source signal, then gradually increase the volume to the
required listening level.
E-4