Amplicomms RingFlash 250 Manual De Instrucciones página 26

Using the RingFlash 250
6. Screw the housing screw (5) back in the
housing (2) of the pick-up.
7. Insert the pick-up in the holder. Pay atten-
around in the holder. The latches for the
the correct installation position.
Assembling on a door bell
1. Use the tape supplied to attach the holder
of the pick-up on the doorbell. Position the
holder so that the large opening in the hol-
der is over the doorbell's sound generator.
2. Press your doorbell.
3. When the Status LED (1) on the pick-up
lights up, the pick-up transmits a signal to
the base station.
26
Assembling on a smoke alarm
1.
holder beside the smoke alarm. Position
the holder so that the pick-up is installed
as close as possible to the sound genera-
tor of the smoke alarm.
Never install the pick-up directly on the
smoke alarm. If you position the pick-up
directly on the smoke alarm, the function
of the smoke alarm can no longer be gua-
ranteed.
2. Activate the test function of your smoke
alarm. (Refer to the operating manual
supplied with the smoke alarm.)
The pick-up must be exposed to a smoke
alarm signal for 5 seconds. The transmis-
sion only triggers the RingFlash 250 base
station after this period.