Sears Kenmore 116.20212 Manual Del Proprietário página 16

3.Turn
POWER-
MATE
TM
over,
To remove
cover, insert
screwdriver at
cover tabson
both sides and
twist to
release tabs,
Quick
Release
5. Carefully
insert and
twist
screwdriver
at each
brush
support to
free brush
from base
6. Remove
worn bee
Brush
Support
4. Turn POWER-
MATE
TM
right
side up. Press
handle release
pedal and lower
the swivel. T ilt
cover forward
from back until
front snaps free..
7. Slide brush
supports off to
check and clean
brush support
areas° See
BRUSH
ASSEMBLY for
picture of
complete brush
assembly,
TO REPLACE BELT:
I. Slide washers and brush supports onto
brush assembly°
2. Install
new belt
over motor
drive, then
over brush
sprocket,
NOTE: See
PARTS AND
FEATURES
for Belt #.
I
Brush
Support
Motor
Drive
Brush
Brush Sprocket
3. Snap brush
supports into
place on base.
Be sure brush
supports are
not upside-
down.
4. Line up
front of cover
and base.
Rest cover
on front edge
of base as
shown.
Cover Bass
5. Tilt cover to
back. Press
cover firmly until
side labs snap
into place.
Replace cover
screws, light
bulb and light
cover.
16