Operating Instructions; Stamp Impressions Up To 20 X 20 Mm; Stamp Impressions From 20 X 20 Mm Up To 20 X 60 Mm; Limits Of Use - Trodat DRYTEQ SET Manual De Uso

7. Insert the ink cartridge with the coloured (ink) side
down into the stamp until it engages in the middle.
Note
Store unused ink cartridges in the closed
bag, in a cool, dry place. Avoid open storage.

6 Operating instructions

6.1 Stamp impressions up to 20 x 20 mm

Note
The surfaces to be stamped must be clean,
dry, dust-free and free of grease.
1. Stamp an impression in the desired place.
2. Turn on the UV curing unit with the on/off
switch (ready for use after 2.5 sec-onds).
Battery status light glows:
• Green with a full battery charge (100%)
• Yellow with a half battery charge (50%)
• Red with a low battery charge (10%)
• When the battery is dead (0%), the battery status
will flash red. You must charge the device.
3. Position the UV curing unit flush with the
fresh impression.
4. Briefly press the push button.
A fully covered impression cures after a 0.5 second
exposure time.
6.2 Stamp impressions from 20 x 20 mm
1. In order to activate the 2-second mode, keep the
push button pressed when you are switching the
curing unit on. The maximum exposure time
is 2 seconds.
2. Place the curing unit flush over the fresh
impression.
The narrow height of the stamp impression must
be covered.
3. Keep the push button pressed and move the
exposure unit sideways over the impression
for 2 seconds.
During the exposure time, the status indicator
light glows blue. After this, the cooling phase
is set for 10 seconds (yellow flashing light).
When turned off, the 0.5 second mode will
automatically return as default.
• The light sources (LEDs) cannot be replaced.
• In case of defective light sources, replace the
entire dryteq UV exposure device.
• The permissible operating temperature
is 0°C to 40°C.
14
EN
up to 20 x 60 mm

6.3 Limits of use

15
EN