Tabla de contenido
Publicidad
ASSEMBLY
Tools Required
• Adjustable Wrench
• #2 Phillips Screwdriver
Assemble Drill Press Stand
Do not attempt to use
WARNING
your Universal Drill Press
Stand unless it is fastened firmly to your
workbench or floor. Failure to do so
may result in serious injury.
G (1)
M (1)
P (1)
1. Secure base (A) to a solid object
such as a workbench or a clamped-
down board. Four holes are provided
in the base for mounting (hardware
not included).
2. Insert post (B) into base. Make sure
plastic cap is on top. Install and
tighten base bolt (G) securely. See
Figure 1.
B
G
H (1)
N (1)
Plastic Cap
A
Figure 1
3. Assemble adjustment handle (D) to
head assembly (C) with square nut
(H). Place square nut in recess in
back of head assembly. Insert
adjustment handle through head
assembly and thread it into square
nut three full turns. See Figure 2.
D
H
4. Assemble depth stop by sliding depth
stop collar (J) onto the depth stop
carriage (K) from the bottom with the
round side of the collar matching the
round side of the carriage. Secure
the collar by screwing the depth stop
adjustment knob (L) in the threaded
hole. See Figure 3.
L
7
C
Figure 2
K
J
Figure 3
Publicidad
Tabla de contenido
