How To Use - Makita 2705 Manual De Instrucciones

ENGLISH
1. Bolt
2. Tire wheel
3. Leg
4. Nut
5. Washer
6. Sleeve
CAUTION
• Read and thoroughly understand this manual and the instruction manual of the tool you use before performing the
following.
• Before installing a tool on this stand, always switch off and unplug the tool.
• The stand should be bolted in a stable and level surface using the bolts provided on two of four feet.
• Use only with Makita model indicated in the instruction manual.
• Use only the handle to avoid pinched fingers when raising or folding the stand.
• Before operating the tool, secure it to stand using bolts.
• Do not use the stand on uneven or unstable surface.
• Do not climb, sit or stand on the stand.
• When storing table saw stand, never lean it against the wall or the like lengthwise or sideways.
Assembling
1. Overturn the stand and place the tire wheels on the inside surface of legs.
Secure them to fix the axis with bolt, washer and nut by tightning firmly with two wrenches. (Fig. 1, 2)
2. Mount the table pipe on the table saw stand securely using the bolts with hex wrench. (4 pcs.). (Fig. 3)

How to use

3. When securing table saw on the table saw stand, place it on the table saw stand so that the handle of stand is
positioned on the right side in the front view of the mounted saw and holes on your tool base match holes in the stand.
Then tighten bolts (4 positions) securely. (Fig.4)
4. Place the table saw stand on a level location. When setting up the table saw stand in the upright position, turn the
handle clockwise. (Fig. 5)
5. Adjust the levelness of the table saw stand by rotating the foot, and then secure the table saw stand by turning the
nuts. (Fig. 6)
6. Secure the foot of stand to the stable and level surface using holes in the fix plates with two hex bolts. (Fig. 7)
7. To fold the table saw stand, turn the handle counterclockwise. (Fig. 8)
Explanation of general view
7. Bolts
8. Table pipe
9. Holes in the stand
10. Holes in your tool base
11. Table-raising / lowening wheel
handle
12. Fix plate
13. Foot
14. Hex bolts
3