Tabla de contenido
Publicidad
FIGURE 1.
MOUNTING AND WIRING INSTRUCTIONS
GB
NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation
instructions do apply to this fixture.
The light source of this luminaire is not replaceable; when the light source reaches its end of life
the whole luminaire shall be replaced.
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread mounting screws (A) into mounting bar (B). Secure the mounting screws (A) with hex
nuts (C).
3. Place mounting bar flush against ceiling at desired mounting location. Using outside mounting
bar holes as a guide, mark where pilot holes are to be drilled.
4. Inset two plastic anchors (D) into the pilot holes (for drywall ceiling).
5. Align outside mounting bar holes with plastic anchors (D) (If applicable). Secure mounting
bar (B) into place using wood screws (E).
6. Make an electrical connection by loosening the terminal screws on the terminal block (M) and
inserting the live, neutral and ground terminals.
7. Tighten terminal screws. Make sure there are no stray wires.
8. Raise canopy (H) to ceiling, allowing mounting screw (A) to protrude through openings in
canopy (H) and secure into place with washer (I) and cap nuts (T).
9. Removing screw nuts (F) from fixture cover (G) to remove cage shade (J) and glass shade (K),
carefully support the cage shade (J) while removing screw nuts (F) from fixture cover (G), then
remove the glass shade (K).
10. Install lamp (not supplied). (Please do not exceed the maximum capacity recommended on
the socket).
11. Secure the glass shade (K) to fixture cover (G), and secure the cage shade (J) using the screw
nuts (F).
12. Turn power back on at circuit box.
GS-26-FS33-WH20
D
A
B
C
E
H
I
T
F
G
K
J
M
11
Publicidad
Tabla de contenido
