Safety Information - UFESA DH1UF18M Instrucciones De Uso

Safety information

This appliance is intended for domestic use
and the household environment only.
Install and operate the appliance as de-
scribed in the text and illustrations. We do
not accept liability for damage resulting
from failure to heed these instructions.
This appliance is intended for use up to an
altitude of 2000 m above sea level.
The appliance may only be installed and
stored in a frost-free room (due to residual
water).
Risk of electric shock!
Switch off the mains voltage supply
immediately if a fault occurs.
Immediately shut off the cold water
supply to the appliance should it leak.
The continuous-flow heater may only be
connected and put into operation by a
qualified professional.
In order to avoid potential sources of
danger, repairs and maintenance may
only be undertaken by a suitably quali-
fied specialist.
Never open the appliance without discon-
necting the power supply beforehand.
The statutory regulations of the respective
country, as well as those of the local electric-
ity and water suppliers, must be adhered to.
The continuous-flow heater is a Class I
appliance and must be connected to the
protective earth.
The appliance must be permanently
connected to installed pipes. The conduc-
tor cross-section must comply with the
installed appliance power.
Caution: Earthed water pipes may give the
appearance of a connected protective earth.
To guarantee compliance to relevant safety
regulations, an all-pole separator must
be fitted during installation. The contact
opening must be at least 3 mm.
The continuous-flow heater is only suitable
for closed (pressurised) operation.
The tap and outlet fittings must be ap-
proved for operation with closed (pressur-
ised) continuous-flow heater systems.
8
EN
Only connect the continuous-flow heater
to a cold water line.
The continuous-flow heater is suitable for
connection to DVGW-tested plastic pipes.
Disconnect the electrical connection
cable from the supply and shut off the
water supply before connecting the
appliance!
Connect the water supply and then
connect the electrical supply.
Only make the openings which are re-
quired for installation on the rear of the
appliance. If the appliance is reinstalled,
the unused openings must be provided
with watertight sealing.
Do not touch electrically live parts after
installation.
The appliance should be disconnected
from the electrical mains supply when
working on the water supply. After service
work is complete, proceed as during the
first-time appliance start-up.
No changes may be made to the appliance.
The appliance may only be used for heat-
ing drinking water for household use.
This appliance can be used by children
aged 8 years and older as well as by per-
sons with diminished bodily, sensory or
mental perception, or those who lack
knowledge or experience, if they are moni-
tored or have received instruction concern-
ing use and comprehend the possible dan-
gers that can result. Children may not play
with the appliance. Cleaning and mainte-
nance by the user may not be performed
by unsupervised children.
Keep children away from the appliance.
Please monitor children to ensure that they
do not play with the appliance.
The mixer and the warm water pipe may
be hot. Please inform and instruct children
appropriately.
Do not use aggressive or abrasive cleaning
detergents!
Do not use a steam cleaner.
The appliance is only to be descaled by a
suitably qualified specialist.