EHEIM Clear Serie Manual De Instrucciones página 16

English
‧ Repairs must only be carried out by an EHEIM service centre.
‧ Do not carry the appliance by the mains cable, and to disconnect from
the mains, always pull on the plug and not on the cable or appliance.
‧ Protect the mains cable against heat, oil and sharp edges. If the con-
nection cable has been laid in the ground or in gravel without an empty
conduit, it must not be possible to step on it.
‧ Only carry out the work described in these instructions.
‧ Never make technical modifications to the appliance.
‧ Only use original spare parts and accessories for the appliance.
‧ Only operate the appliance when there are no persons in the water!
‧ Never use the UVC lamp outside of the housing.
‧ Never look into the UVC lamp's light.
‧ The electrical installations must comply with the international and
national erection specifications.
‧ The appliance must be protected by a residual current protection device
with a maximum rated residual current of 30 mA.
‧ Please contact an electrician if there are any questions or problems.
‧ Disconnect the appliance from the mains before all work.
‧ The electrical data of the appliance must match the data of the power
mains. This data is found on the type plate, the packaging and in these
instructions.
‧ Extension cables and power distributors must be suitable for outdoor
use (protected against splashing water).
‧ According to VDE, the device's safety distance from the water must be
at least 2 m.
‧ Mains connection cables must not have a smaller cross-section than
rubber hose lines with the abbreviation H05RN-F3G0,75. Extension
cables must meet the requirements of DIN VDE 0620.
‧ The mains connection cable of this appliance cannot be replaced. If the
cable is damaged, the appliance must be scrapped.
‧ Protect the mains socket and mains plug against moisture
and wetness. A drip loop must be formed with the mains
cable.
16