Kenmore 253.6000 Serie Manual De Uso Y Cuidado página 11

First Steps
9. Unscrew bottom hinge pin using
adjustable wrench. Move hinge pin to
other hole in hinge and tighten with
adjustable wrench.
10. Reverse door handles (see instruction
on next page).
11. Unscrew and move the freezer
and refrigerator door stops to the
opposite side of the doors. Before
inserting screws, use an awl to
puncture the door foam.
12. Position refrigerator door onto bottom
hinge pin. Remove hinge hole plug
from top of door and insert it on
opposite side. Screw center hinge pin
through center hinge into top of door.
Close refrigerator door to help align
hinge hole.
13. Tighten center hinge pin with
adjustable wrench.
14. Remove top cabinet hole plugs and
freezer door hinge hole plug. Insert
removed hole plugs into corresponding
holes on opposite side of refrigerator.
Do not leave open holes.
15. Lower freezer door onto center hinge
pin.
16. Close freezer door. Lift up on handle
side of door and grasp the thinnest
part of the top hinge cover (which
was removed in Step 2) and insert
the thickest part between the doors
on the handle side approximately 3
inches from the outside edge. This will
ensure proper spacing when the top
hinge screws are tightened.
17. Position top hinge on opposite side of
cabinet from which it was removed.
Insert top hinge screws and tighten
hinge to cabinet. Check door gasket
for open seal condition (gap between
gasket and cabinet flange). Remove
the hinge cover from between the
doors and install it back in place over
the top hinge.
Look for open areas between the
gasket and the cabinet flange.
Gasket should seal against the
cabinet all the way around including top
11
and bottom