Electrical Connections - Pego ECPAPE03 Manual De Uso

CHAP. 2 - Installation
2.5
Warning
: The positive pole of the battery (Fastom with red wire) is initially disconnected
to maintain the charge during product storage.
Once the in-room keypad connections have been made it is, therefore, necessary to
connect this fastom to the connector marked (1) on the upper left side of the board as also
indicated on the wiring diagram.
It is advisable to first connect the control unit to the relative emergency pushbutton and
only then connect up the battery and the mains power. This will prevent activation of the
alarm.
Rev.01-18

ELECTRICAL CONNECTIONS

+
USE AND MAINTENANCE MANUAL
- ENG -
ECPAPE03
Pag. 19