Melchioni Family WALLY Manual De Usuario página 12

3. Switch the appliance on by selecting the desired setting.
4. Please operate the machine according the control keys on the control panel or the infrared controller. （you can
see the control panel and infrared controller in this paper）
1
"0" is "OFF". "I": is "ON".
4、Turn on the power switch, LED display Environment temperature,
"POWER" light on, the appliance is standby; see picture 1
5、At the right side of the appliance base have a switch, Press
"START/STOP", High heat and Swing, press again, the appliance will
shutdown. see picture 2.1-2.2
6、All function need to be operated by infrared controller.
4、Fan keep working for 30 seconds when shutdown the appliance (after
heating).
Note: The indicator lights when corresponding function is working.
2.1 2.2
Infrared controller：
5、Press "On/off" as follows: ON(Fan working, FAN light on), OFF(Fan
keep working for 30 seconds when shutdown the appliance after
heating), see picture 5.1
6、Press "Heating" as follows: Low heat (LOW light on), High heat (HIGH
light on), FAN working. see picture 6.1-6.2
7、Press "SWING" as follows:, SWING ON (SWING light on), SWING OFF,
see picture 7.1
8、Press "TIMER" to set timer as follows: 1H,2H,3H.....8H(TIMER light
on), see picture 8.1-8.4
9, Press "+" "-" to set temperature, Temperature range: 18-45℃. see
picture 9.1-9.2
10、Press "Cancel" to cancel temperature setting.
11、For example, Environment temperature is 26 ℃, See picture 11.1
Press "-", Set temperature is equal to or lower than Environment
temperature, appliance will stop heating. See picture 11.2-11.3
Press "+", Set temperature is 1℃ higher than Environment temperature,