Vacuuming Tips - Sears Kenmore 116.29229 Manual De Uso

6. To turn vacuum
cleaner on, step on
the ON/OFF switch.
7. To turn on
PowerMate ®, move
the
FLOOR/CARPET
switch to the
CARPET position.
NOTE - When this switch is in the FLOOR
position, the headlight DOES NOT function
since no electricity flows to the PowerMate ®.
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may require
that they be vacuumed with the PowerMate ®
agitator turned off, to prevent carpet
damage.
CAUTION
DO NOT leave the PowerMate ® running
in one spot in the upright position for any
length of time. Damage to carpet may
occur.
VACUUMING TIPS
WARNING
Personal injury and Product Damage
Hazard
DO NOT run over power cord with
PowerMate ®. Personal injury or product
damage could result.
DO NOT pull plug from wall by
the power cord. If there is damage to
the cord or plug, personal injury or
property damage could result.
CAUTION
Product Damage Hazard
Use care if the PowerMate ® and wand is
left in the upright position as it may tip
over easily. Property damage can occur if
tipped.
Suggested sweeping pattern.
For best cleaning action, the PowerMate ®
should be pushed straight away from you
and pulled straight back. At the end of each
pull stroke, the direction of the PowerMate ®
should be changed to point into the next
section to be cleaned. This pattern should
be continued across the carpet with slow,
gliding motions.
NOTE: Fasb jerky strokes do not provide
complete cleaning.
The hose swivel allows the hose to turn
without moving the canister. This is helpful
for cleaning in small areas.
Check hose for
twisting before
pulling canister.
- 10-