RIDGID AC9956 Manual Del Operador página 3

OPERATION
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING:
Keep fingers, hands, and all body parts away from
moving clamps. Failure to do so could result in
possible serious injury.
WARNING:
STOP IMMEDIATELY IF THE WORKPIECE OR
WORK STATION MOVES WHEN OPERATING.
Failure to do so could result in possible serious
injury.
SETTING UP THE WORK STATION
See Figures 1 - 8, pages 6 - 7.
 Place the work station upside down on a flat level surface.
 Unlock the leg lock lever.
 Slide the rear leg to the back of the work station releasing
it from the storage position.
 Lift the leg slightly then slide the leg toward the front of
the work station.
 Raise the leg and slide it down into place before locking
the leg lock lever.
 Unlock the foot lock lever.
 Depress the upper lock button to release the adjustable
foot.
 Tilt the adjustable foot until it is perpendicular to the rear
leg and push down to engage the lower lock button.
 Lock the foot lock lever.
 Lift the foot pedal and pull toward the front of the work
station until it clicks into place.
 Slide the right front leg lock toward the center of the
workstation and hold in place.
 Lift the right front leg and pull to the front of the work
station.
 Release the right front leg lock to secure the leg in place.
Repeat this process to lift and secure the left leg.
NOTE: When the legs are secure, the lock levers will
prevent them from folding. DO NOT use this product if
the legs cannot be secured.
 Turn the work station over placing it upright on the ground.
Recheck that all levers are locked and all legs are secured
firmly into place.
CAUTION:
To reduce the risk of injury, never attempt to lift
the work station until each leg has been properly
secured in place.
FOLDING AND/OR CARRYING THE WORK
STATION
See Figures 8 - 13, pages 7 and 8.
 Tighten the thumbscrew on the side of the sliding clamp
to secure it in place.
 Pull the lock / unlock latch up to unlock.
 Step down on the foot pedal then let the pedal rise
completely.
 Turn the work station over and place it upside down on
the ground.
 Slide the right front leg lock toward the center of the
workstation and hold in place.
 Lower the right front leg until it rests on the housing.
Repeat this process to lower the left leg.
 Place a finger in the foot pedal release and pull up to
unlock the foot pedal.
 Lower the foot pedal until it rests on the front legs.
 Unlock the foot lock lever.
 Depress the lower lock button to release the adjustable
foot.
 Tilt the adjustable foot until it is parallel to the rear leg and
push it toward the leg to engage the upper lock button.
 Lock the foot lock lever.
3 - English