AEG KRC 4355 CD Instrucciones De Servicio página 36

English
36
7 F.FWD button (scan forwards)
8 STOP button (stop)
9 OPEN/CLOSE button (open/ close CD tray)
10 PLAY/PAUSE button (play/pause)
11 TUNING control
12 STANDBY/AL.OFF button (on/standby / alarm off)
13 FUNCTION button (function)
14 MUTE button (mute)
15 ALARM SET button (set alarm)
16 TIME SET button (set time)
17 SLEEP/SNOOZE button (sleep timer/ snooze)
18 M button (memory upwards)
19 M button (memory downwards)
20 LCD display
Rear side (not shown)
Power cord
Wire antenna
AUX IN jack (2xRCA)
Bottom side (not shown)
Battery compartment
Remote control
21 MEM/PROG button
22 button
23 REPEAT button
24 button
25 AL.SET button
26 OPEN/CLOSE button
27 FUNCTION button
28 SLEEP button
29 SNOOZE button
30 TIME SET button
31 M button
32 M button
33 (increase volume)
(decrease volume)
/ (scan forward/ next song)
/ (scan backwards/ previous song)
34 button
35 button
Sub-structure assembly instructions
If you don't want to use the device as a standalone appliance,
then please assemble it as follows:
• Remove all objects from the cupboard and anything
which is fragile in the adjacent cupboards.
• For the installation the cupboard must fulfil the following
conditions:
Thickness of the cupboard floor
between 16 mm and 20 mm.
• The wall mounting of the cupboard must be stable and
anchored firmly in the wall with at least 2 screws.
• Important! Do not install the device above a cooker!
• When installing the device it must be ensured that there
is a power socket within reach.
• The mains socket must be within easy reach, so that the
plug can be quickly removed in an emergency.
• Important! Do not connect the device to the mains
power supply until after installation!
• The device cannot be installed under cupboards under
which there is a lighting strip.
• For mounting, you may need the following supplies:
Reamer or nail, screwdriver, measuring tape, adhesive
tape, scissors, safety goggles.
Supplied mounting accessories
1 Drilling template
3x 3 screws (different lengths)
3x 3 spacers (different sizes)
WARNING:
Screws that are driven in too far (screws that are too long)
can damage the device or can result in danger to life.
CAUTION:
• Please adhere to the dimensions stated in the installa-
tion instructions.
• You should use only the installation accessories sup-
plied.
Installation
1. Tape the template into the cabinet with adhesive tape.
With the help of a gimlet or nail pierce the crosses at the
attachment points and use it to mark the holes.
2. Remove the template and drill the holes into the wall-
mounted cabinet.
3. Stick the spacers into the provided mounting brackets on
the device.
NOTE:
Adequate ventilation is only guaranteed with spacers.
4. Countersink the screws into the holes in the cabinet.
5. Select the screws according to the spacers used. Fasten
the kitchen radio to the bottom of the cabinet with the 3
screws and the spacers.
6. Tighten the screws finger tight with a screwdriver.
CAUTION:
Use a screwdriver and not a cordless screwdriver.
Start-up of the device / Introduction
NOTE:
You will find some buttons on both the device and the
remote control. Identical buttons fulfil the same function.