Basic Safety Information - Tetra LED Light Wave Instrucciones De Uso

Information
ATTENTION!
These notes warn of a situation which leads to
material damage or environmental pollution.

Basic safety information

Proper use
The LED light is designed to illuminate aquariums in
enclosed rooms.
Proper use also includes heeding all the information
in these instructions and in particular complying with
the safety information.
Any other or additional use shall be deemed
improper. Improper use may result in damage to
property or injury to persons and shall render the
warranty null and void.
Improper use of the LED light exists in particular in
the following cases:
• If you immerse the LED light fully or partly in water
• If you carry out unauthorised modifications or
repair work to the LED light
• If you use the LED light outside enclosed rooms
Tetra GmbH will not accept liability for damage
caused by improper use.
Prevention of electric shock
• Ensure that the LED light and all the electrical
devices in the aquarium are disconnected from the
mains supply in the following situations:
− Before you reach into the water in the aquarium
− Before you change the water
− Before you carry out cleaning or maintenance
work
− If there are visible signs of damage to electrical
devices or mains cables
− In the event of faults
− If you do not intend to use the aquarium for a
lengthy period.
English translation of the original German instructions
• Do not allow children and people who require
supervision to handle the LED light. These people
cannot always make an accurate assessment of
potential risks.
• Only use earthed sockets (230 V ~ 50 Hz) to supply
power.
• Make sure that the mains supply system is
protected by an AC/DC-sensitive residual current
circuit-breaker (RCCB).
• Do not immerse the LED light fully or partly in
water
• Never touch the power cable and plug with wet
hands.
• Make sure that the socket is immune to the ingress
of water and moisture.
• Unwind the mains cable fully. Do not kink or crush
the power cable.
• The mains plug must be easily accessible so that
the LED light can be disconnected from the power
supply quickly in an emergency.
• Pull only on the plug to remove it from the socket –
do not pull on the power cable.
Never repair or modify the LED light
without authorisation. Do not replace
the LED yourself. Electrical work may
be carried out only by the Tetra
Technik Service Center or trained
electricians.
Prevention of asphyxiation
• Do not allow children to play with packaging films.
Prevention of cuts
• If any glass parts of the aquarium are broken, there
is a danger of cuts.
− Never touch the edges of shards of glass.
− Wear gloves.
− Remove all shards of glass carefully.
9