Before First Use - Saivod EXB-45 P Manual De Instrucciones

for examination ,repair or adjustment
16 The use of accessory attachments not recommended by the appliance manufacturer may cause
injuries
17 Do not store any materials other than manufacturers recommended accessories in this unit
when not in use
18 if the supply cord is damaged ,it must be replaced by the manufacturer ,its service agent or
similarly qualified persons in order to avoid a hazard

Before first use

1 Danger: Keep the packaging material away from children .they could suffocate
2 Unpack the citrus juicer and remove all of the packaging
3 Material Examine the juicer for visible damage and check that all of the parts are present
4 You should clean the appliance before using it for the first time
5 Wipe the motor base with a damp cloth
6 Before using the juicer for the first time, rinse the cones, strainer, juice container and transparent
dust lid with warm water and a few drops of washing-up liquid.
operation
1 Setting up the juicer
2 Stand the appliance on an even surface that is easy to clean
3 Unwind the power cord – to the length you require – from the cord storage compartment
(underneath the juicer). Make sure that the cord is correctly
4 Connect the mains plug to a AC230V,50Hz socket outlet
Selecting accessories
1 Depending on the size of the fruit you are juicer, you can use the large or the small cone
2 The large cone is suitable for juicing small citrus fruit ,such as grapefruit ,oranges etc
3 The small cone is suitable for juicing small citrus fruit, such as lemons, limes etc.
4 Fit the small juicing cone directly onto the drive shaft
5 If you wish to use the large cone, fit the small cone onto the drive shaft. Then fit the large cone
over the top of the small cone.
6.You must feel the notches in the large cone clip into place over the stirring wings on the small
cone.
7.To separate the cones, pull the large cone up and off.
Juicing
Caution: if you apply too much pressure to the juicing cone, the motor may seize.
11. Remove the transparent dust lid.
12. Fit the appropriate cone onto the drive shaft.
13. The juice appropriate cone onto the drive shaft.