SciCan STATIS 1.5 L Manual Del Operador página 7

Installation
The STATIS 1.5L should be sterilized prior to being operated for the first time. Do not connect or disconnect the handpiece
while the motor is running. Doing so could result in damage to the handpiece and motor.
Connection:
Push the contra-angle onto the E-Type coupling of the motor and twist until the guide stud audibly locks into place.
Before each use, check the connection by pulling the contra-angle to be sure it is securely attached.
Disconnection:
Pull off the contra-angle from the E-Type coupling in an axial direction.
Inserting the Bur:
Insert the press button firmly with the thumb. At the same time, insert the bur into the chuck as far as it will go.
Exert traction on the bur to check that it is correctly in place. Always wear gloves or other adequate protection when
checking and using the device.