Designated Use; Commissioning, Operation - CeoTronics CT-MultiCom Instrucciones De Uso

Important safety information concerning the use of CT-DECT digital radio systems!
 Legal note for operation in the European Union
The transmitter of the CT-DECT device should be used in the European
Union only when it is marked as following:
 Legal note for operation in the USA
The transmitter of the CT-DECT device should be used in the USA only when
it is marked as following:
 Legal note for operation in Canada
The transmitter of the CT-DECT device should be used in Canada only when
it is marked as following:
Improper use!
The use of CeoTronics products for special applications, such as explosive and hazardous areas,
aviation, bomb disposal (EOD / IEED) or other similar applications, is in the sole responsibility of the
end user. The end user has to check and decide that the products can be used without risk.
CeoTronics does not take over responsibility for any damage or material losses nor injuries to persons,
caused by the use described above or by any other abnormal use of the products.

Designated use

2
The CT-MultiCom has a built-in microphone and a built-in speaker. Two sockets are provided for the
connection of earphones and / or headsets. For covert communication there is a 3.5 mm jack socket
allowing the connection of an earphone without switching off the microphone integrated in the CT-
MultiCom. A robust 4-pole socket to MIL C 9177 standard accepts the connection of professional
headsets.
Some CT-MultiCom are equipped with a second PTT transmit button or alternatively with an emergency
call button. On CT-Multicom units with a second PTT transmit button this button is black; on CT-
MultiCom units with an emergency call button it is orange.
The CT-MultiCom is intended for professionals who depend on safe and secure communication even
under difficult surroundings and environmental conditions.
Commissioning – Operation
3
3.1 Connection to the radio - and voice transmission

Make sure the storage battery of the radio is fully charged.

Switch the radio OFF.

Connect the CT-MultiCom to the radio.
On radios, the accessory interface of which is alive even in switched-off condition (e.g. STP
8000), the LED of the CT-MultiCom flash up Red, then Green and go out followed by an audio
signal.
Revision: 11/0317  DOK 1412-d-be-f-nl-esp-pl
15 / 60
English