HOLD
This function enables you to interrupt a con-
versation temporarily without ending the call.
Press the
button to interrupt the conver-
sation temporarily.
Inserting a dialing pause (PABX)
Press the
button to interrupt dialing for
3.6 seconds.
Inquiry button (HOOK/ FLASH)
This function is required in order to activate
certain T-Net features. If you press the
button, the telephone line is interrupted for
a certain length of time (300 ms – fixed
setting).
Speed-dial buttons
Assigning numbers to the speed-dial
buttons
You can assign any telephone numbers to
the 6 speed-dial buttons.
1. Lift up the receiver or press the
2. Press the
3. E nter the "telephone number" you require.
4. Press the
button again.
5. A ssign a speed-dial button to the tele-
phone number which you have entered
by pressing one of the
6. Then replace the receiver or press the
button.
18 English
button.
....
buttons.
M1
M6
Dialing with speed-dial buttons
Lift up the receiver or press the
If you press any of the
telephone number which is stored there is
dialed.
Note: If the telephone is disconnected from
the mains/telephone network for more than
60 minutes, the stored telephone numbers
will be deleted.
Settings
Setting the call signal volume
The telephone's ringer volume can be set by
means of a slide switch on the back of the
telephone.
Tone/ pulse dialing
You can select the dialing process by means
of a slide switch on the back of the tele-
phone.
Note:
button.
Most telephone lines operate with tone
dialing.
Additional jacks
Headset jack
Standard headset port with a 2.5 mm jack
(for connecting a PL-100/ PL-200, for exam-
ple).
Headphone jack
Headphone output (3.5 mm jack plug) to
connect a set of headphones, teleloop or
similar.
button.
....
buttons, the
M1
M6